Tanking Polymer can be used to waterproof new or old structures. Providing protection from pressure water, ground moisture and dampness.

Tanking Polymer can be applied both internally and externally.

Once mixed, apply to concrete, cement mortar renders or masonry. The Tanking Polymer substance penetrates into the capillary system of the substrate.
The substances fill the capillaries and prevent the ingress of water, becoming an integral part of the structure.

Ensure the substrate is clean, free of dust, cracks or any previous coatings. Mix the Tanking Polymer by hand or electric paddle, mix 25kg of product with 7.9 litres of clean water to produce a thick, workable 'yoghurt' consistency.

The Polymer should be applied at a rate of 2.5kg per square metre with a block brush to produce a coat no more than 3mm thick. A minimum of 2 coats is required.

Contact with wet cement, wet concrete or wet mortar may cause irritation, dermatitis or burns.
Contact between cement powder and body fluids (e.g. sweat or eye fluids) may also cause irritation, dermatitis or burns.
There is a risk of serious damage to eyes.
Wear suitable protective clothing, gloves and eye/face protection.
In case of contact with eyes, rinse immediately with plenty of clean water and seek medical advice.
After contact with skin wash immediately with plenty of clean water. Keep out of reach of children.

Safety data sheet available for professional users on request. Always follow the manufacturer's recommendations when using this product. It is the users' responsibility to determine suitability.